Service manual

CHAS
INSTALLATION
4-53
9. Install:
• Handlebar
• Handlebar holders
NOTE:
The handlebar should be installed in the posi-
tion assigned by the position mark
CAUTION
First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
NOTE:
Before installing the handlebar onto the hand-
lebar crown, apply a light coat of lithium soap
base grease onto the handlebar end and install
the throttle housing to the handlebar.
10. Install:
• Brake master cylinder
NOTE:
• Install the master cylinder bracket with the
“UP” mark facing upward.
• Tighten first the upper bolt, then the lower
bolt.
11. Install:
• Clutch cable
NOTE:
Apply a light coat of lithium soap base grease
onto the clutch cable end
Bolt (Handlebar holder):
12 to 28 Nm (1.2 a 2.8 m·kg, 8.80
to 20.5ft·lb)
Bolts (Master cylinder bracket):
5 to 8 Nm (0.5 a 0.8 m·kg, 3.6 to
5,8ft·lb)