Service manual
CHAS
CHECKING THE DRIVE CHAIN
4-69
CAUTION
This motorcycle has a drive chain with
small rubber O-rings between the drive
chain side plates. Never use high-pressure
water or air, steam, gasoline, certain sol-
vents (e.g., benzine), or a coarse brush to
clean the drive chain. High-pressure met-
hods could force dirt or water into the drive
chain’s internals, and solvents will deterio-
rate the O-rings. A coarse brush can also
damage the O-rings. Therefore, use only
kerosene to clean the drive chain. Don’t
soak drive chain in kerosine more them ten
minutes. O-ring is damage by kerosine.
4. Check:
• O-rings
Damage
Replace the drive chain.
• drive chain rollers
Damage/wear
Replace the drive chain.
• drive chain side plates
Damage/wear
Replace the drive chain.
Cracks
Replace the drive chain and
make sure the battery breather hose is
properly routed away from the drive chain
and below the swingarm.
5. Lubricate:
• drive chain
6. Check:
• drive sprocket
• rear wheel sprocket
More than 1/4 tooth a wear
Replace
the drive chain sprockets as a set.
Bent teeth
Replace the drive chain
sprockets as a set.
b Correct
Drive chain roller
Drive chain sprocket
Recommended lubricant
Engine oil or chain lubricant sui-
table for O-ring chains