Service manual

ENG
ENGINE DISASSEMBLY
5-14
CAUTION
• Use soft hammer to tap on the case half.
• Tap only on reinforced portions of case.
• Don’t tap on gasket mating surface.
• Work slowly and carefully.
• Make sure the case halves separate
evenly. If one end “hangs up”, take pres-
sure off the push screw, realign, and
start over. If the cases don’t separate,
check for a remaining case screw or fit-
ting.
• Don’t force.

2. Remove:
• Dowel pins 
• Damper collar 
3. Remove:
• Bearing retainer 
SHIFTER, TRANSMISSION AND BALANCER
WEIGHT
1. Remove:
• Guide bars 
• Shift cam 
• Shift forks 
NOTE:
Note the position of each part. Pay particular
attention to the location and direction of shift
forks.
2. Remove:
• Transmission assembly
Tap lightly on the transmission drive axle
with a soft hammer.
1
1
2
1
2
3
1