Service manual

ENG
INSPECTION AND REPAIR
5-24
EAS00288
CHECKING THE CLUTCH PUSH RODS
1. Check:
• O-ring 
• short clutch push rod 
• long clutch push rod 
• ball 
Cracks/damage/wear

Replace the
defective part(s).
2. Measure:
• long clutch push rod bending limit
Out of specification

Replace the long
clutch push rod.
EAS00292
CHECKING THE PRIMARY DRIVE
1. Check:
• primary drive gear
• primary driven gear
Damage/wear

Replace the primary
drive and primary driven gears as a set.
Excessive noise during operation

Replace the primary drive and primary dri-
ven gears as a set.
2. Check:
• primary-drive-gear-to-primary-driven-gear
free play
Free play exists

Replace the primary
drive and primary driven gears as a set.
Long clutch push rod bending limit
0.15 mm (0.0059 in)
3
4
2
1