Service manual

ELEC
SIGNAL SYSTEM
8-28
1. Bulb
• Remove the bulb.
• Connect the pocket tester (Ω 1) to the bulb
terminals.
Positive tester probe

terminal 
Negative tester probe

terminal 
• Check the bulb for continuity.
FLASHER LIGHT DOES NOT BRINK
2. Bulb socket
• Install the bulb to the sockets.
• Disconnect the flahser light leads  from
the wire harness.
• Connect the pocket tester (Ω 1) to the flas-
her light leads.
When checking right flasher light:
Positive tester probe

Dark Green 
Lead
Negative tester probe

Black  Lead
When checking left flasher light:
Positive tester probe

Chocolate 
Lead
Negative tester probe

Black  Lead
• Check the bulb socket for continuity.
• Is the bulb socket OK?
Replace the bulb
YES
NO
Replace the bulb
socket.
YES
NO
A
B
FRONT
REAR