Service manual

CHK
ADJ
LUBRICATING THE DRIVE CHAIN/
CHEEKING AND ADJUSTING THE STEERING HEAD
3-30
09*92/61
*0139
VTLD
E0610
0000000
5
83 dB (A
) - 4000 m
in-
1
EAS00142
LUBRICATING THE DRIVE CHAIN
The drive chain consists of many interacting
parts. If the drive chain is not maintained pro-
perly, it will wear out quickly. Therefore, the
drive chain should be serviced, especially
when the motorcycle is used in dusty areas.
This motorcycle has a drive chain with small
rubber O-rings between each side plate.
Steam cleaning, high-pressure washing, cer-
tain solvents, and the use of a coarse brush
can damage these O-rings. Therefore, use
only kerosene to clean the drive chain. Wipe
the drive chain dry and thoroughly lubricate it
with engine oil or chain lubricant that is suita-
ble for O-ring chains. Do not use any other
lubricants on the drive chain since they may
contain solvents that could damage the O-
rings.
EAS00146
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the motorcycle on a level surface.
ss
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so
that the front wheel is elevated.
2. Check:
• steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness

Adjust the steering
head.
3. Remove:
• side covers, seat, fuel tank, main switch
protector.
Remove handlebar from its position.
Remove handle crown.
4. Adjust:
• steering head
Recommended lubricant
Engine oil or chain lubricant sui-
table for O-ring chains