Service manual

CHK
ADJ
CHECKING AND TIGHTENING THE SPOKES/
CHECKING AND LUBRICATING THE CABLES
3-37
2. Tighten:
• spoke
(with a spoke wrench)
NOTE:
Be sure to tighten the spokes before and after
break-in.
EAS00170
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the
inner and outer cables.
ss
WARNING
Damaged outer cable may cause the cable
to corrode and interfere with its movement.
Replace damaged outer cable and inner
cables as soon as possible.
1. Check:
• outer cable
Damage

Replace.
2. Check:
• cable operation
Rough movement

Lubricate.
NOTE:
Hold the cable end upright and pour a few
drops of lubricant into the cable sheath or use
a suitable lubricating device.
2~3.5 Nm (0.2~0.35 m•kg,
1.42~2.49 ft•lb)
Recommended lubricant
SAE 10W30 Motor Oil