Owner`s manual

3-2
1 2 3 4 5
6
EAU03034
Indicator and warning lights
EAU03587
Oil level/coolant temperature
warning light “WARNING”
This warning light has the following
three functions.
8 When the engine oil level is low,
the warning light comes on and
symbol “7” flashes. If this
occurs, stop the engine immedi-
ately and add engine oil to the
specified level.
1. Oil level/coolant temperature warning
light “WARNING”
2. Oil level symbol “7”
3. Coolant temperature symbol “ ”
4. Turn signal indicator light “5”
5. High beam indicator light “&”
6. Neutral indicator light “N”
8 When the coolant temperature is
too high, the warning light comes
on and symbol “ ” flashes.
Stop the motorcycle and allow it
to idle until the coolant tempera-
ture goes down. If the tempera-
ture does not go down, stop the
engine. (See the “Engine over-
heating” section on page 6-44 for
further instructions.)
8 When the engine oil level is low
and the coolant temperature is
too high, the warning light flash-
es and symbols “7” and “ ”
come on.
To check that the warning light is
working properly:
8 Put the transmission in neutral or
apply the clutch lever.
8 Turn the engine stop switch to
“#” and the key to “ON”.
8 The light will come on and sym-
bol “7” will appear in the dis-
play.
If the warning light does not come on,
have a Yamaha dealer inspect the
electrical circuit.
EC000118
cC
8 Do not operate the motorcycle
until you know that the engine
oil level is sufficient.
8 Do not operate the engine if it
is overheated.
NOTE:
Even if the oil is filled to the specified
level, the indicator light may flicker
when riding on a slope or during sud-
den acceleration or deceleration, but
this is normal.
EAU00057
Turn signal indicator light “5”
This indicator light flashes when the
turn signal switch is pushed to the left
or right.
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
4TP-9-21 7/25/00 3:46 PM Page 20