Owner`s manual

6-10
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
3. Remove the drain bolt and drain
the oil.
4. Install the drain bolt and tighten it
to the specified torque.
5. Fill the engine with sufficient oil
to reach the specified level.
Install the oil filler cap and tight-
en it.
EC000079
cC
In order to prevent clutch slippage
(since the transmission oil also
lubricates the clutch), do not mix
any chemical additives with the oil.
6. Start the engine and warm up for
a few minutes. While warming
up, check for oil leakage. If oil
leakage is found, stop the engine
immediately and check for
cause.
EAU01808
Coolant
To check the coolant level
1. Place the motorcycle on a level
surface and hold it in an upright
position.
NOTE:
8 The coolant level must be
checked on a cold engine since
the level varies with engine tem-
perature.
8 Make sure that the motorcycle is
positioned straight up when
checking the coolant level. A
slight tilt to the side can result in
a false reading.
Tightening torque:
Drain bolt:
15 Nm (1.5 m0kg)
1
1. Drain bolt
Recommended oil:
See page 8-1.
Oil quantity:
Total amount: 0.85 L
Periodic oil change: 0.8 L
4TP-9-21 7/25/00 3:46 PM Page 52