Owner`s manual

6-41
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
4. Push the wheel forward, and
then remove the drive chain from
the rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
5. Remove the wheel.
ECA00048
cC
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
EAU01806
To install the rear wheel
1. Install the drive chain onto the
rear sprocket, and then insert the
wheel axle from the left side.
NOTE:
Make sure that there is enough
space between the brake pads
before inserting the brake disc
between the pads.
2. Install the swingarm end bolts,
and then lower the rear wheel so
that it is on the ground.
3. Adjust the drive chain slack.
(See page 6-26 for drive chain
slack adjustment procedures.)
4. Tighten the axle nut and
swingarm end bolts to the speci-
fied torques.
1
1. Swingarm end bolt (×2)
3. Remove the swingarm end bolt
from each end of the swingarm.
Tightening torque:
Axle nut:
103 Nm (10.3 m0kg)
Swingarm end bolts:
3 Nm (0.3 m0kg)
4TP-9-21 7/25/00 3:46 PM Page 83