User Manual

TRIGGER ReferenceKITMIDI VOICEUTILITY WAVEPATTERN
UTILITY Setting Area (UTIL)
Owner’s Manual 83
System Settings
In the GENERAL section, you can set parameters affecting the
entire system. With the GENERAL page (UTIL1) displayed,
press the [ENTER] button to access its eight parameter-setting
pages (UTIL1-1 to UTIL1-8). You can use the [B]/[C] buttons
to navigate between these pages.
1 Master volume
Use this parameter to set the master volume of the instru-
ment’s internal tone generator. If a small value is set here, the
VOLUME dial on the front panel will have very little effect in
increasing the output volume.
1 Master tune (M.Tune)
Use this parameter to tune (i.e., adjust the basic pitch of) the
internal tone generator. The value in parentheses shows the
corresponding tuning (of A above middle C) in Hertz.
• The term “cent” refers to one hundredth of a semitone (i.e., 100 cents
= 1 semitone).
1 StartupKit
Use this parameter to specify the kit to be automatically
selected when the DTX-MULTI 12 is turned on. Kits are
identified using a category (P for Preset, U for User) and a
number, and you can move the cursor using the [B]/[C]
buttons to set these individually.
1 Startup pattern (StartupPtn)
Use this parameter to select the pattern that will be automati-
cally set when the DTX-MULTI 12 is turned on. Patterns are
identified using a category (
e P for Preset, e U for User) and a
number, and you can move the cursor using the [B]/[C]
buttons to set these individually.
1 Startup trigger (StartupTrg)
Use this parameter to select the trigger setup that will be auto-
matically selected when the DTX-MULTI 12 is turned on.
Trigger setups are identified using a category (P for Preset, U
for User) and a number, and you can move the cursor using
the [B]/[C] buttons to set these individually.
1 Variation effect (var)
B Chorus effect (cho)
C Reverb effect (rev)
Use these parameters to specify which effects will be
bypassed when Effect Bypass is activated from the front panel
(using the [SHIFT] and [KIT] buttons). When “---” is selected
for an effect type, it will not be bypassed.
UTIL1 GENERAL
UTIL1-1 Master Volume page
Settings 0 to 127
UTIL1-2 Master Tune page
Settings -102.4 to +0.0 to +102.3
UTIL1-3 Startup Kit page
Settings P001 to P050 or U001 to U200
UTIL1
≥≥≥≥GENERAL
UTIL1-1<GENERAL>
MasterVolume=127
1
UTIL1-2≥≥M.Tune=
+≥≥0.0(440.0Hz)
1
NOTE
UTIL1-3<GENERAL>
StartupKit=P001
1
UTIL1-4 Startup Pattern page
Settings eP001 to eP128 or eU001 to eU050
UTIL1-5 Startup Trigger page
Settings P01 to P05 or U01 to U10
UTIL1-6 Effect Bypass page
Settings ---/var, ---/cho, or ---/rev
UTIL1-4<GENERAL>
StartupPtn=©P001
1
UTIL1-5<GENERAL>
≥StartupTrg=P01
1
UTIL1-6≥≥FXByps=
≥≥var/cho/rev
1 2 3