User manual

58
DTX-PROX Owner’s Manual
Troubleshooting
Reference
Having difficul-
ties during perfo-
mance
Cymbal/Hi-hat sounds
are too soft
The DTX-PROX pro-
duces sound but the
sensitivity (i.e., volume)
is too low.
Orientation of the cymbal
pad is incorrect
Shaft on the Hi-hat pad is
loose
Extra felt is attached
The pad type or trigger
parameter setting is incorrect
LED rotary fader is set at the
minimum level
The level settings for the pad
are improper
• Check the orientation of the cymbal pad.
When it is improper, the cymbal pad
may not be fully functional.
• The shaft on the hi-hat stand may come
loose during use and cause the hi-hat
pad to rotate. If this happens, the pad
may not function properly. To avoid the
problem, we recommend that you
tighten the shaft and check the position
of the hi-hat pad on a regular basis.
• Putting extra felt under the cymbal pad
may result in lower volume.
• Ensure that the Pad Type parameter is
set correctly. (A suitable cymbal-pad
type must be selected for the pad being
used. (For more information, refer to the
“Reference Manual” (PDF).)
• The trigger output level of any pads with
a dial allow this to be adjusted.
page 27
Assembly
Manual
• Ensure that the LED rotary fader for the
pad for which a sound is not being pro-
duced is set high enough.
page 35
Sound is produced with-
out striking the pad
Sound is produced by a
pad that was not struck
(Crosstalk is occurring)
For more information, refer to the “Refer-
ence Manual” (PDF).
Reference
Manual
(PDF)
Cannot choke
Cannot mute
Check the orientation of the cymbal pad.
When the orientation of the pad is
improper, the cymbal pad may not func-
tion fully.
page 27
Assembly
Manual
Foot closed hi-hat
sounds cannot be played
It is difficult to produce
closed hi-hat sounds
Shaft on the Hi-hat pad is
loose
Extra felt is attached
LED rotary fader is set at the
minimum
level
The level settings for the pad
are improper
• Make sure that you are fully and firmly
operating the hi-hat pedal.
• Ensure that the foot controller is cor-
rectly connected to the [CONTROL]
jack.
• Putting extra felt under the cymbal pad
may result in lower volume.
Assembly
Manual
• Ensure that the LED rotary fader for the
pad for which a sound is not being pro-
duced is set high enough.
page 35
Pads with position sens-
ing do not produce
sounds properly
• Ensure that the Pad Type and trigger
parameters have been set correctly. (For
more information, refer to the “Refer-
ence Manual” (PDF).)
• Check the orientation of the cymbal pad.
When this is not set properly, the cymbal
pad may not be fully functional.
• Make sure to connect the pad to the
proper jack that supports position sens-
ing.
page 27
Assembly
Manual
Symptom Possible cause Solution
Reference
page