Owner`s manual

Assembly Guide

DTX400K/DTX430K/DTX450K Owner’s Manual

Attaching the first/second tom part

1. Take the first/second tom part (y) from the package,

and using the tuning key, securely tighten the s key

bolts.

2. Loosen the  key bolts.

3. Slide the first/second tom part (y) onto the vertical

supports and move it down until the tops of the supports

are flush with the tops of the holes. Ensure that the tom

part is oriented as shown in the above figure at this time.

4. Tighten the  key bolts to secure the first/second tom

part (y) in place.

The details of are different for the DTX400K, DTX430K, and DTX450K.

Attaching the snare

pad

1. Take the snare part (i) from the pack-

age and lightly tighten the wing bolt.

2. Place the snare part (i) on the left arm, which was

assembled in , and slide it back until the front

end of the arm is flush with the joint.

3. Securely tighten the wing bolt.

4. Loosen the  key bolt located on the back of the snare

pad (i), and rotate the pad 180°, turning it over.

5. Tighten the  key bolt to secure the snare pad (i) in

place.

Step 6

Rear of first tom pad

Rear of second

tom pad

Vertical supports

This part has two s key bolts, one each on the left and right.

This part has two

 key bolts, one each on the left and right.

Care should be taken to avoid assembling the first and sec-

ond tom pads upside-down or back-to-front.

The tom pads will be rotated into place in .

NOTE

Step 12

Step 7

For DTX400K Owners

Step 7

Wing bolt

Left arm

Joint

Step 4

180°