Owner`s manual

Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
45
4-1. Clutch Position
Using the following procedure, you can simulate the effect
of changing the hi-hat’s clutch position. The smaller the set-
ting, the quicker an open hi-hat sound will decay.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [4] to select the Hi-hat Settings
parameter group.
3. Press number button [1] to select the Clutch Position
parameter.
4. Enter a new clutch position using number buttons [1] to
[10/0].
4-2. Splash Sensitivity
Using the following procedure, you can set the degree of
sensitivity for detecting hi-hat foot splashes. The higher the
value, the easier it will be to produce a foot-splash sound
with the hi-hat controller. High values may, however, result
in splash sounds being unintentionally produced when, for
example, you operate the hi-hat controller lightly as you
keep time. It is a good idea, therefore, to set this parameter
to “Off” if you do not want to play foot splashes.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [4] to select the Hi-hat Settings
parameter group.
3. Press number button [2] to select the Splash Sensitivity
parameter.
4. Enter a new splash sensitivity using number buttons [1]
to [10/0].
4-3. Foot Close Position
Using the following procedure, you can adjust the position
at which the hi-hat switches from open to closed when you
operate the hi-hat controller. The lower the value, the
smaller the virtual opening between the top and bottom hi-
hats. Larger values increase the size of the gap between the
top and bottom cymbals, and this can prevent foot close or
foot splash sounds from being produced when you operate
the pedal.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [4] to select the Hi-hat Settings
parameter group.
3. Press number button [3] to select the Foot Close Posi-
tion parameter.
4. Enter a new foot close position using number buttons
[1] to [10/0].
4-4. Foot Close Velocity
Using the following procedure, you can adjust the velocity
(or power) of foot-close sounds produced using the hi-hat
controller.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [4] to select the Hi-hat Settings
parameter group.
3. Press number button [4] to select the Foot Close Veloc-
ity parameter.
4. Enter a new velocity using number buttons [1] to [10/0].
v Hi-hat Settings
Steps:
MENU ([KIT] + [SONG])  [4]  [1]  Setting
Setting
0 to 64
Steps:
MENU ([KIT] + [SONG])  [4]  [2]  Setting
Setting
0 to 127
Set this parameter to [0] in order to turn off foot splashes.
Setting
Setting
NOTE
Steps:
MENU ([KIT] + [SONG])  [4]  [3]  Setting
This parameter only has an effect when you are
using an HH65 Hi-hat Controller.
Setting
0 to 32
Steps:
MENU ([KIT] + [SONG])  [4]  [4]  Setting
This parameter only has an effect when you are
using the hi-hat controller that comes with the
DTX400K.
Setting
1 to 127
Setting
Setting