User Manual

Assembly Guide
DTX400K/DTX430K/DTX450K Owner’s Manual
17
is only required for the DTX430K and DTX450K. Owners of the DTX400K should skip to .
Assembling the kick pad
1. Take the kick pad (!3) from the pack-
age, remove the four wing bolts, spring
washers, and flat washers from the
kick pad holder, and arrange each set
nearby in the disassembled condition.
2. Assemble the base to the holder as shown below, and
then from the base side, assemble the wing bolts, spring
washers, and flat washers removed in
1. in order to
secure it in place.
3. Take the foot pedal (!5) from the package and insert the
beater into the hole in the holder as shown below.
4. Slide the beater rod into the hole until the tip protrudes
approximately 15 mm from the rear, and then tighten
the beater bolt using the tuning key.
5. Turn the foot pedal’s T-bolt counter-clockwise to loosen
it.
6. Fit the raised section at the front of the kick pad holder
into the foot-pedal’s assembly bracket.
7. Turn the foot pedal’s T-bolt clockwise to secure the
parts together.
8. Operate the pedal and confirm whether the beater head
strikes the kick pad near the center. If not, adjust the
length of the beater or move it left or right as required.
Positioning the hi-hat controller and kick drum
Arrange the hi-hat controller (!4) and the kick drum parts or
kick unit (!5) as shown in the figure on the left.
Step 13
Step 14
Step 13
!3
Wing bolt
Spring washer
Flat washer
Kick pad
Kick padBase
!5
Beater Tuning key
Holder
Connecting
rod
Connecting rod
Beater bolt
T- b o l t
Beater head
Assembly bracket Raised section T-bolt
Step 14
DTX400K
!4
!4
!5
DTX430K/DTX450K
Kick drum parts
IMPORTANT
The hi-hat controller (!4) and the kick unit (!5) from the
DTX400K are almost identical in appearance. They can be
told apart by the sticker on the base section.