User Manual

Assembly Guide
DTX400K/DTX430K/DTX450K Owner’s Manual
18
Fine-tuning the positions of the pads and the drum module
Sit on your stool and adjust the positions of the pads and the
drum module to your liking.
• To adjust the height of the snare pad, loosen the  key bolt.
• To adjust the height of the third tom pad, loosen the
 key bolt.
• To adjust the height of the drum module, loosen the
s key bolt.
• To tilt the drum module forwards or backwards, loosen the

key bolt.
Connecting the pads to the drum module
1. Insert the mini plugs* at one end of the nine-channel
snake cable (!6) into the correct trigger input jacks
(SNARE to KICK/PAD) on the right side of the drum
module. (*: The smaller set of plugs.)
2. Insert the nine-channel snake cable’s standard plugs*
into the jacks in the corresponding pads. (*: The larger
set of plugs.)
3. Wrap the cables for the snare pad, the tom pads, and the
cymbal/hi-hat pads around the cable clips to prevent
them from being pulled out.
4. Using the cable bands (!8), secure the cables to the kit
rack at the positions in the figure above.
Congratulations—You have finished assembling
your electronic drum kit!
Step 15
Drum module
Snare pad
Third tom
pad
CAUTION
• Be sure to always retighten any key bolt after you have
finished adjusting the corresponding part.
• Before moving on to the next step, ensure that all key
bolts have been tightened.
• Refer back to if you wish to readjust the angle of the
snare pad.
• Refer back to if you wish to readjust the angles of the
tom pads.
NOTE
Step 7
Step 12
Step 16
RIDESNRHH
KICKHHCHHCRRIDETOM3TOM2TOM1SNR
TOM2TOM1CR TOM3 KICK HHC
RIDE
SNR
HH
KICK
HHC
TOM3
TOM2
TOM1
CR
KICK HHC
DTX400K
Right side of the drum module
Nine-channel snake cable
The sticker on each of the snake cable’s plugs indicates the
name of the corresponding pad.
NOTE
Excessive bending can damage the cables. Ensure, there-
fore, that they are not bent at an extreme angle when
wrapped around the clips.
NOTICE