User Manual

Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
43
2-3. Pad Panning
Using the following procedure, you can adjust the panning
of the current kit’s pads.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [2] to select the Kit Settings
parameter group.
3. Press number button [3] to select the Pad Panning
parameter.
4. Strike a pad to select it.
5. Enter a new panning position using number buttons [1]
to [10/0]. A value of 64 corresponds to the center posi-
tion. Smaller values than this move the pad increasingly
towards the left; larger values move it towards the right.
2-4. Double Bass Drum
Using the following procedure, you can easily configure the
drum module to produce a kick drum sound when you oper-
ate the pedal connected to the [HI-HAT CONTROL] trig-
ger input jack. This convenient function provides support
for double bass drumming techniques.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [2] to select the Kit Settings
parameter group.
3. Press number button [4] to select the Double Bass Drum
parameter.
4. Set the parameter using number button [1] or [2]. The
available settings are as follows.
2-5. Reverb
Reverb effects add a warm ambience to sounds, simulating
the complex reflections of actual performance spaces, such
as a concert hall or a small club. Use the following proce-
dure to select a reverb effect for the current kit.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [2] to select the Kit Settings
parameter group.
3. Press number button [5] to select the Reverb parameter.
4. Select a reverb effect using the corresponding number
button ([1] to [10/0]). The available settings are as fol-
lows.
Steps:
MENU ([KIT] + [SONG])  [2]  [3]  Setting
Setting
0 to 127
Steps:
MENU ([KIT] + [SONG])  [2]  [4]  Setting
Number button Setting
[1] Off
[2] On
While the Double Bass Drum function is enabled, you will be
unable to use the hi-hat controller plugged into the [HI-HAT CON-
TROL] trigger input jack to simulate opening and closing of the hi-
hat.
Setting
Setting
NOTE
Steps:
MENU ([KIT] + [SONG])  [2]  [5]  Setting
Number button Setting
[1] Off
[2] Hall 1
[3] Hall 2
[4] Hall 3
[5] Room 1
[6] Room 2
[7] Room 3
[8] Stage 1
[9] Stage 2
[10/0] Plate
Setting