User Manual
Table Of Contents
- Owner’s Manual
- About the Manuals
- Included Accessories
- Introduction
- Getting Started
- Connecting the AC Power Cable
- Connect powered speakers (Sold separately for Upright piano)
- Turning the Power On/Off
- How to use the Silent Piano™ Function (For Pianos Equipped with the Silent Piano™ Function)
- Connecting the Product and Smart Device to a Network
- Choosing the Network Connection Method
- Wireless Network Connection by WPS
- Wired Network Connection
- Direct Wireless Connection
- Using the ENSPIRE Controller App
- IDC Registration
- Other Settings
- Troubleshooting
- Glossary
- Specifications
- Appendix
Getting Started
2
Chapter
24
Note:
If this product is connected directly
to your smart device, no Internet
access is available on your smart
device.
You can use this product as an access point to establish a direct wireless
connection between this product and your smart device.
1 Press the [P] (Standby/On) button to turn the power off.
2 Connect the USB wireless LAN adaptor (UD-WL01) to the
[USB] terminal on the rear of the switch box.
Note:
As a default, the [WLAN] switch is
set to the “RT” position.
3 Set the [WLAN] switch on the rear of the switch box to “AP.”
4 Press the [P] (Standby/On) button to turn the power on.
When this product is set as an access point, the LED lamp of the USB
wireless LAN adaptor (UD-WL01) lights up. You can now use this
product as an access point.
Note:
For details on the Wi-Fi setting,
refer to the owner’s manual supplied
with your smart device.
5 Open the Wi-Fi setting screen on your smart device.
6 Enable the Wi-Fi function.
Note:
[DKV**********] differs
depending on each Disklavier.
7 From the network list shown on the screen, tap on
[DKV**********].
Direct Wireless Connection
LED lamp
WPS button
[WLAN] switch