User Manual

62
DTX-PRO Owner’s Manual
Reference
Message List
Message Description
Are you sure? Confirms whether or not you want to execute the specified operation.
Auto power off disabled. Appears when the [–] button is held down while turning on the power
informing the user that the Auto Power Off function is disabled.
Backup error. Appears when writing data to the DTX-PRO has failed.
If data was not be properly saved when turning off the unit, this mes-
sage appears the next time the power is turned on. After the error
message appears, the Factory Reset automatically executes.
Canceled. Appears when the cancel operation is complete.
Can’t process. The DTX-PRO cannot process a requested operation.
Completed. Appears when execution of a Kit Store, File Load/Save, Job, or other
function is complete.
Connecting USB device... Appears when connecting to a USB device.
Excessive demand for USB power. Power consumption of the USB device exceeds the specified value.
Factory Reset initializing... Appears on startup if you did a factory reset.
File already exists. A file with the same name already exists.
File not found. The selected file type was not found.
Illegal file. Appears when loading a file and the DTX-PRO cannot handle the
tar- get file or does not support the audio file.
Incompatible USB device. Appears when an unsupported USB device is connected to the [USB
TO DEVICE] terminal.
Invalid USB device. The USB device is faulty. Format the USB device again.
Keybank full. Appears when the total number of keybanks for waveforms have
exceeded the maximum capacity.
No data. Appears when the target data does not exist when using the
Recorder or using Wav-related parameters under “Job.”
No response from USB device. There is no response from the USB device.
Now importing... Appears when importing a .wav file.
Now loading... Appears when loading a file.
Now processing... Appears when executing a Kit Store or Job operation. Appears
during post-processing after canceling the File Load or File Save
operation.
Now saving... Appears when saving a file.
Overwrite? Appears when saving a file to the USB device and a file with the
same name already exists in the USB device.
Appears when attempting to rerun the Store User Kit operation for
the Kit previously saved.
Please stop recorder. Appears when performing an operation that exits the Recorder
during recorder playback or recording. Stop the Recorder and try
again.