User Manual

Setup Procedures

DTX900

2-2. Storing Pad Types

Store your pad type settings on the drum trigger module as a User Trigger Setup to ensure they are not lost.

1. Press the [TRIGGER] button to access Trigger mode.

2. Press the [ENTER/STORE] button.

3. Turn the data dial to select the Trigger Setup number in which you wish to store your settings.

4. Press the [ENTER/STORE] button. You will be asked to confirm that you wish to proceed. Press the [DEC/NO] button to

cancel the process without storing any settings.

5. To proceed, press the [INC/YES] button.

2-3. Selecting a Drum Voice

Select the drum voice(s) you wish to play for each input jack.

1. Press the [DRUM KIT] button to access Drum Kit mode.

2. Press the [F2] VOICE button, and then the [SF1] SELECT button to call up the Select page.

3. Press the [SF5] button to set “SOURCE”.

4. Strike the head or rim whose Trigger Input Jack you wish to change. Alternatively, you can move the cursor to q, and then

change the setting by pressing the [DEC/NO] and [INC/YES] buttons.

5. Move the cursor to the Voice Category (w) and Voice Number (e) parameters, and select the desired category and voice by

using the [DEC/NO] and [INC/YES] buttons.

Notice

Never attempt to turn off the drum trigger module while the message “Please keep power on” is shown. If this precaution is not

observed, user data may be lost or the internal system may be damaged, rendering your drum trigger module unable to startup nor-

mally when it is next turned on.

NOTE

If you have connected a DT50S to the [!0KICK/!1] jack, “Kick” will be displayed when you strike the head, and “Pad11” will be displayed when

you strike the rim.

Destination Trigger Setup number for storing

w e