User Manual

UTILITY
DTX700 Reference Manual
38
Auxiliary Output Selection (AuxOutSel)
Use this parameter to indicate where audio input via the [AUX
IN] jack will be output.
Settings: L&R+ph, phones
PlayCount
Use this parameter to activate (on) or deactivate (off) a two-mea-
sure lead in before a song starts playing.
Settings: off, on
AutoPowerOff
Use this parameter to set the amount of time for which the
DTX700 must be idle before it will turn off automatically. In
addition to settings of 5, 10, 15, 30, 60, and 120 minutes, you can
disable this function by selecting “off”.
Settings: off, 5, 10, 15, 30, 60, 120
LCD Mode
Use this parameter to switch the screen display mode between
normal (i.e., dark letters on a bright background) and reverse (i.e.,
the opposite).
Settings: normal, reverse
UTILITY/MASTER EQ
 Setting the Master Equalizer
The parameters from the Menu area’s Utility/Master
EQ page can be used to adjust the master equalizer
that shapes the tone of voices, songs, and other
audio output. In specific terms, this three-band mas-
ter equalizer allows the signal level to be freely
boosted or cut around a center frequency specified
for each of the bands. In addition, the “low” and
“high” frequency bands can be set to either shelv-
ing or peaking type equalization.
NOTE
• The settings on this page will change if you adjust the master
equalizer from the Kit area (accessed by pressing the [KIT]
and [F1] buttons).
• Master equalization has no effect on audio input via the [AUX
IN] jack (see page7).
L&R+ph
The auxiliary-input audio will be output via the
OUTPUT jacks ([L/MONO] and [R]) and the
[PHONES] jack.
phones
The auxiliary-input audio will be output via the
[PHONES] jack only.
UTILITY/GENERAL 3/3
For master equalizer settings
UTILITY/MASTER EQ 1/5 to 5/5
Gain
Low High
Frequency (Hz)
Q
Three EQ bands
Mid