User Manual

Assembly Guide
DTX400K/DTX430K/DTX450K Owner’s Manual
15
The details of are different for the DTX400K, DTX430K, and DTX450K.
Attaching the hi-hat
holder
1. Loosen the two key bolts on the joint on the snare-
pad part, which was attached in .
2. Take the hi-hat holder (!1) from the package and slide it
into the joint from the front as shown in the figure. Then
adjust the angle of the hi-hat holder.
When correctly inserted, the tip of the hi-hat holder
(!1) will protrude slightly from the rear of the joint.
When correctly oriented, the metal rod section at the
top of the hi-hat holder (!1) will be vertical.
3. Tighten the two key bolts to secure the hi-hat holder
(!1) in place.
Attaching the hi-hat
holder
1. Loosen the two key bolts on the joint on the left arm,
which was attached in .
2. Take the hi-hat holder (!1) from the package and slide it
into the joint from the rear as shown in the figure. Then
adjust the angle of the hi-hat holder.
When correctly inserted, the tip of the hi-hat holder
(!1) will protrude slightly from the front of the joint.
When correctly oriented, the metal rod section at the
top of the hi-hat holder (!1) will be vertical.
3. Tighten the two key bolts to secure the hi-hat holder
(!1) in place.
Attaching the cymbal holders
1. Loosen the four key bolts at the ends of the first/sec-
ond tom part, which was attached in .
2. Take the cymbal holders (!0) from the package and
insert them into the ends of the first/second tom part.
Then adjust the angles of the cymbal holders until they
are oriented as shown in the figure.
When correctly inserted, the tips of the cymbal hold-
ers (!0) will protrude slightly from the bottom of the
tom part.
When correctly oriented, the cymbal holders (!0) will
be as shown in the figure.
3. Tighten the four key bolts to secure the cymbal hold-
ers (!0) in place.
Step 8
For DTX400K and DTX430K Owners For DTX450K Owners
Step 8
!1
Snare pad
Joint
Step 7
Step 8
!1
Left arm
Joint
Step 4
Step 9
!0!0
The two cymbal holders are identical.
Step 6
NOTE