User Manual

18
DTX900 Data List
[5] PHASER MONO
No. Parameter Range
1 Speed 0.1Hz − 10.0Hz
2 Manual 0 − 127
3 Depth 0 − 127
4 Feedback 0 − 127
5 Stage 4, 6, 8, 10, 12, 16
6 Mode 1, 2, 3
7 Color 0 − 127
8 —
9 —
10 —
11 —
12 —
13 —
14 —
15 —
16 —
The Color parameter is not available in the following conditions : When Mode is set to 1
and Stage is set to 4, 6, 8, 12 or 16 : or when Mode is set to 2 and Stage is set to 4 or 10.
[6] PHASER STEREO
No. Parameter Range
1 Speed 0.1Hz − 10.0Hz
2 Manual 0 − 127
3 Depth 0 − 127
4 Feedback 0 − 127
5 Stage 4, 6, 8, 10
6 Mode 1, 2
7 Color 0 − 127
8 Spread 0 − 127
9 —
10 —
11 —
12 —
13 —
14 —
15 —
16 —
The Color parameter is not available in the following conditions : When Mode is set to 1
and Stage is set to 4, 6 or 8 : or when Mode is set to 2 and Stage is set to 4 or 10.
[7] TEMPO PHASER
No. Parameter Range
1 LFO Speed 16th − 4thx16
2 LFO Depth 0 − 127
3 Phase Shift Offset 0 − 127
4 Feedback Level -63 − +63
5 LFO Phase Reset off(free run), Key On Reset, SEQ Start Reset
6 − 9 : Same as the parameters shaded in gray in CROSS DELAY on page 15.
10 Dry/Wet Balance D63>W − D=W − D<W63
11 Stage 4 − 22
12 Diffusion mono/stereo
13 —
14 —
15 —
16 —
[8] DYNAMIC PHASER
No. Parameter Range
1 Sensitivity 0 − 127
2 Dyna Level Offset 0 − 127
3 Feedback Level -63 − +63
4 Attack Time 0.3ms − 227ms
5 Release Time 2.6ms − 2171ms
6 Release Curve 0 − 127
7 Direction up, down
8 Dyna Threshold Level 0 − 127
9 —
10 Dry/Wet Balance D63>W − D=W − D<W63
11 Stage 4, 5, 6
12 —
13 − 16 : Same as the parameters shaded in gray in CROSS DELAY on page 15.
Category - TREMOLO&ROTARY
[1]AUTO PAN
No. Parameter Range
1 LFO Speed 0.0Hz − 39.7Hz
2 L/R Depth 0 − 127
3 F/R Depth 0 − 127
4 Pan Direction L<>R, L>>R, L<<R, Lturn, Rturn, L/R
5 LFO Wave 0 − 28
6 − 9 : Same as the parameters shaded in gray in CROSS DELAY on page 15.
10 —
11 EQ Mid Frequency 100Hz − 10.0kHz
12 EQ Mid Gain -12dB − +12dB
13 EQ Mid Width 0.1 − 12.0
14 —
15 Input Mode mono/stereo
16 —
[2]TREMOLO
No. Parameter Range
1 LFO Speed 0.0Hz − 39.7Hz
2 AM Depth 0 − 127
3 PM Depth 0 − 127
4 —
5 —
6 − 9 : Same as the parameters shaded in gray in CROSS DELAY on page 15.
10 —
11 EQ Mid Frequency 100Hz − 10.0kHz
12 EQ Mid Gain -12dB − +12dB
13 EQ Mid Width 0.1 − 12.0
14 LFO Phase Difference -180deg − +180deg
15 Input Mode mono/stereo
16 —
[3] ROTARY SPEAKER
No. Parameter Range
1 Rotor Speed Slow 0.0Hz − 2.65Hz
2 Horn Speed Slow 0.0Hz − 2.65Hz
3 Rotor Speed Fast 2.69Hz − 39.7Hz
4 Horn Speed Fast 2.69Hz − 39.7Hz
5 Slow-Fast Time of Rotor 0 − 127
6 Slow-Fast Time of Horn 0 − 127
7 Drive Rotor 0 − 127
8 Drive Horn 0 − 127
9 Rotor/Horn Balance R63>H − R=H − R<H63
10 —
11 − 14 : Same as the parameters shaded in gray in CROSS DELAY on page 15.
15 Mic L-R Angle 0deg − 180deg
16 Speed Control Slow, Fast
Effect Parameter List