User Manual

102 Owner’s Manual
TRIGGER Setting Area (TRG)
TRG2-1-4 Velocity Range page
1 Velocity
Use these parameters to specify the maximum and minimum
velocities corresponding to the settings made on the Input
Level Range page (TRG2-1-3). When struck, the selected
pad(s) will produce sounds within this velocity range.
TRG2-1-5 Double Trigger Prevention page
When a stick or beater strikes a pad, it may rebound and strike
again, producing a second trigger signal and causing a voice to
sound twice. The term “double trigger” is used to refer to this
phenomenon. A reject-time setting is used to prevent double trig-
gers from occurring, and the DTX-MULTI 12 will reject any sec-
ond input signals produced during this time period.
1 Reject time
Use this parameter to specify the time period after a pad is
struck during which a second input signal will be ignored.
The larger the value set here, the longer the period during
which a second sound will not be produced.
• Double triggers may not be rejected in cases where the pad-type
selection on the Pad Type page (TRG2-1) is other than a DT-series
pad and the input level of the second strike within the reject time is at
least twice that of the first strike.
The term “crosstalk” refers to the output of trigger signals from a
pad other than the one that was stuck as a result of vibration or
interference between pads. From the Crosstalk Prevention page,
you can set input levels below which trigger signals will not be
produced, thus preventing crosstalk. With this page displayed,
press the [ENTER] button to access the Global Crosstalk Level
page (TRG2-2-1) and the Individual Crosstalk Level page
(TRG2-2-2). You can switch between these parameter-setting
pages using the [
B ]/[ C ] buttons.
• The input level indicator shown on the upper row of text on the
crosstalk level pages (TRG2-2-1, TRG2-2-2) is identical to that from
the Pad Type page (TRG2-1). Accordingly, it is not covered in the fol-
lowing page descriptions.
TRG2-2-1 Global Crosstalk Level page
1 Pad
Use this parameter to select the pad(s) for which a crosstalk
level is to be set. You can also strike a pad to select it.
• Selection by striking is limited to pad groups (i.e., UP, MID, or LOW)
and the external pads (i.e., 13 to 17).
B Crosstalk level
Use this parameter to specify a level for preventing crosstalk
from all of the DTX-MULTI 12’s other pads. If the input level
produced at the pad indicated by 1 is lower than this level
whenever any of the other pads are struck, it will be treated as
crosstalk and no trigger signal will be generated. Although
higher setting values are more effective in preventing
crosstalk, they can also make it difficult to play multiple pads
at the same time.
Settings
Minimum velocity: 0 to 126
Maximum velocity: 1 to 127
Settings 4ms to 500ms
TRG2-1-4≥-MID-˛¸
Velocity=≥≥0-127
1
TRG2-1-5≥-MID-˛¸
RejectTime=500ms
1
NOTE
TRG2-2 Crosstalk Prevention page
Settings UP, MID, LOW, or 01 to 17
Settings 0% to 99%
TRG2-2≥≥≥≥≥≥≥≥˛¸
≥≥≥Crosstalk
NOTE
TRG2-2-1≥-¡£-≥˛¸
Level=≥25%(ALL)
1
2
NOTE