Manual

Preparation
Never make or change connections with
the power of this unit turned on.
• Depending on the component you wish
to connect, there are various ways to
make connections. Possible connections
are described below.
• Refer to the manuals of your other
components as necessary to make the
best connections.
. Do not connect this unit via your VCR.
The video quality could be distorted by
the copy protection system.
. Do not connect the audio out jack of
this unit to the phono in jack of your
audio system.
You need to set "DiGiTAL
OUTPUT" to "ALL" (see "DiGiTAL
OUTPUT" on page 23),
Notes:
- If the audio format of the digital output
does not match the capabilities of your
receiver, the receiver produces a distorted
sound or no sound at all. Make sure to
select the appropriate audio format from
the menu screen on the disc
PressingAUDIO on the remote control once
or more may change not only the audio
language but also the audio format. The
selected format appears in the front panel
display for several seconds.
- If you wish to enjoyDalbyDigital, DTS, and
MPEG formats, you must connect this unit
to an AV receiver that supports these
formats.
This unit has a coaxial digital out jack.
Connect DIGITAL OUT - COAXIAL jack
of this unit to your AV receiver equipped
with a Dolby Digital, DTS, or MPEG
decoder using a commercially available
cable.
This unit has analog output jacks.
Connect AUDIO OUT (L/R) jacks of this
unit to the corresponding input iacks of
your audio component (such as a stereo
amplifier) using the supplied audio cable,