Manual

Setup Menu
Progressive
This feature is only valid if you have
connected this unit to a progressive scan
TV through the component video jacks
(see "Component video jacks <A>" on
page 7).
1 In "VIDEO SETUP PAGE", press A/V to
highlight [PROGRESSIVE], and then press
O___N_N
Select this to enable the progressive scan
function.
OFF
Select this to disable the progressive scan
function.
2 Press A/Y to select a setting, and then
press ENTER/OK to confirm your
selection.
Notes on activating progressive scan:
- Ensure that your TV is equipped with
progressive scan.
- Connect using a component video
cable.
- Ensure that "YUV/S" is set to "YUV"
(see "Switching the YUV/S-video" on
page 28).
- When the progressive scan is active, the
VIDEO (CVBS) and S VIDEO jacks do
not output video signals.
- If no picture is displayed, wait for 15
seconds for this unit to activate
automatic recovery, or deactivate
progressive scan manually as follows:
I PressA (OPENICLOSE) on the
front panel to open the disc tray.
2 Press 4.
CONSUMERS SHOULD NOTE THAT NOT ALL
HIGH DEFINITION TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT AND MAY
CAUSE ARTIFACTS TO BE DISPLAYED IN THE
PICTURE. IN CASE OF 52.5 OR 625 PROGRESSIVE
SCAN PICTURE PROBLEMS, IT ISRECOMMENDED
THAT THE USER SWITCH THE CONNECTION
TO THE "STANDARD DEFINITION" OUTPUT. IF
THERE ARE QUESTIONS REGARDING OUR
VIDEO MONITOR COMPATIBILITY WITH THIS
MODEL 525P AND B25P DVD PLAYER, PLEASE
CONTACT OUR CUSTOMER SERVICE CENTER.
This unk is compatible with the complete line of
YAMAHA products, including the pl_)jectors DPX
1200, LPX 510 and the plasma monitor PDM 4220.
Picture settings
This unit comes with three predefined sets
of picture color settings and one personal
setting that you can defne yourself.
1 In "VIDEO SETUP PAGE", press A/_' to
highlight (PICTURE SETTING], and then
press 1_.
STANDARD
Select this for the standard picture setting.
BRIGHT
Select this to make the TV picture
brighter.
SOFT
Select this to make the TV picture softer.
PERSONAL
Select this to personalize your picture
color by adjusting the brightness, contrast,
tint and color (saturation).
2 Press A/V to select a setting, and then
press ENTER/OK to confirm your
selection.
3 Press ANGLE.
26