Manual

1 Toassur_thefinestpelfbrmance,pleasereadthis
manualcarefully.Keepitinasafeplaceforfuture
tolerance,
2 Install this unit in a well ventilated, cool, dr},, clean
place away fiom direct sunlight, heat sources,
vibration, dust, moistu_s, or cold. In a cabinet,
allow about 2.5(m (I inch) of frse space all
around this unit for adequate ventilation,
3 Locate this unit away frorn other electrical appliances,
motors, or t_ansformers to avoid humming sounds,
4 Do not expose this unit to sudden temperatur@
changes from cold to hot, nor locate this unit in
an environment with high humidity (i,e,, a room
with a humidifier) to p_svent condensation inside
this unit which may cause an electdcal shock, fi_s,
damage to this unit, and/or pelsonal injuly,
S Avoid installing this unit where fbreign objects
may fall onto this unit and/or this unit may be
exposed to liquid dripping or splashing, On the
top of this unit do not place;
Other components, as they may cause damage
and/or discoloration on the surface oftNs unit,
Burning objects (i.e., candles), asthey may cause
fir÷, damage to this unit, and/or personal injur7.
Containers with liquid in them, as they may fall,
spilling the liquid and causing an electrical
shock to the user and/or damage to this unit
6 Do not cover this unit with a newspaper, tablecloth,
curtain, etc. in order not to obsSr'uc¢heat radiation.
If the temperaturo inside this unit rises, it may cause
fir\e, damage to this unit, and/or pelsonal in/ury.
7 Do not plug in this unit to a wall outlet until all
connections a_e complete.
8 Do not operate this unit upside down. It may
overheaL possibly causing damage.
9 Do not use excessive fome on switches, knobs
and/or cords,
10 When disconnecting the power cord f_om the
wall outlet, grasp the plug; do not pull the cord,
11 Do not dean this unit with chemical solvents; tNs
might damage the finish, Use a clean, (by cloth,
1"/ Only voltage specified on this un¢ must be used.
Using this unit with a higher" voltage than specified
is dangerous and may cause fir÷, damage to this
unit, and/or personal injur7. YAMAHA will not be
held responsible Br" any damage resulting fiom use
of this unit with a voltage other-than as specified.
13 Do not alSempt to modify or fix this unit Contact
qualified YAMAHA selvice personnel when any
service is needed. The cabinet should never be
opened for any reason.
14 When not planning to use this unit for long
periods of time (i,e,, vacation), disconnect the AC
power plug from the wall outlet.
15 Be sure to _ad the "Troubleshooting" section on
common operating errors before concluding that
this unit is faulty.
16 Before moving this unit, press STANDBY/ON to
set the unit in standby mode, and then disconnect
the AC power plug from the wall outbt.
11 Install this unit near the wall outlet and wher_ the
AC power plug can be _ached easily.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THB UNIT TO
RAIN OR MOISTURE
FOR CANADIAN CUSTOMERS
To prevent electdc shock, match wide blade of plug
to wide slot and fully insert.
This Class B digital apparatus complies with
Canadian ICES 003,
This digital apparatus does not exceed the Class B
limits for" radio noise emissions from digital apparatus
as set out in the Radio Interference Regulations of
the Canadian Department of Communications.
For Customer Use:
Read carefully the inforTnation located at the roar
panel of this unit and enter- below the Serial No.
Retain this inforw_ation for futu_s _sference.
Model No.
Sedal No.
Be sure to place this unit on a level surface,
If you do not do so, PLAYXCHANGE operation of
this unit will not function corTectly, and may damage
the disc(s) and/or this unit itself:
CAUTION
Danger-of explosion if bailer}' is inco_Tectly replaced.
Replace only with the same or equivalent type.
CAUTION
Use of controls or adjustments or per_orTnance of
procedul_s other than those specified he_\ein may
_sult in hazardous radiation exposure.
LASER
Type Semiconductor laser GaAIAs
Wave len_h 650 nm (DVD)
780 nm (VCD/CD)
Output Power 7 mW (DVD)
10 mW (VCD/CD)
Beam divergence 60 degree