Owner`s manual

When the Remote Control's TV orVCR

button does not work even after setting the

device manufacturer code

Try again from step 1 and keep the following points in

mind.

• Make sure you select the Remote Control's TV or VCR

button correctly when setting the narnufaeturer code.

• ff there are multiple manuf_ctur_ codes enter them in

order.

• A_er rein_,i'thlg batteries, try file steps again (within 2

nfinules of"reinserting).

(When rc/lnsei'dng battc_es be careful not to press the

Re,note Control buttons. If a m_nu_eturer code has bcga

set for file TV or VCR button, it may get deleted.)

To return to the factory default settings

While pressing SHIFT down as in step 2 Setting file

Manufaetttrer Code, entcx 299 for TV or 399 for VCR.

(Step 3 is not necessary.)

Maintaining manufacturer code settings

Replace battc_ es Ix_fo_e they Ix_comc unltsable. When the

batteries wear out and yo_t remove them, the custom

manufaetttrcs code sc_ing will stay in memory for about 2

minutes. Be eare_] beeaus_ if more than 2 nfinutas elapse

the codes may be deleted. Also, at this dane, be careful not

to accidentally press a Remote Con_ol button, This can

dcac_ file codes.

While you set the manufacturer code for the "IV or VCFI button, you can use

the following functions after you press the TV or VCFI button.

VCR operation

-- .1 TV F'OWER

*_TV Chamaet S_ection (=)

*_TV Chamaet S_ection ( )

Re_td

V'td_ (._anel SelocOoz ( )

*_Whilc_you 8c-_the TV _slufaClOrCvt co4e for thc_TV butlon, you canop_al_ year lclevision.