Operation Manual

System connections
13 En
English
PREPARATION
2
Connecting the DVD receiver and the
subwoofer
Connect the subwoofer to the DVD receiver using the
system control cable. Attach one end to the subwoofer and
the other to the SYSTEM CONNECTOR terminal at the
rear of the DVD receiver.
– When connecting the system control cable, be sure
to insert the plug until it clicks. When
disconnecting the system control cable, slide the
collar of the plug back to unlock.
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to a short-circuit.
– When connecting the speakers, fix the speaker
cables in place so that cables do not loosen. If your
foot or hand accidentally gets caught on a loose
speaker cable, the speaker may fall.
– To prevent unwanted noise, do not place the
subwoofer too close to the DVD receiver, AC
power adaptor, TV or other sources of radiation.
– Be sure to connect the power cable of the
subwoofer (NX-SW1000) to the AC outlet before
you turn on the DVD receiver (DVR-1000).
Otherwise, the subwoofer (NX-SW1000) will not
be powered correctly.
Notes
SYSTEM
CONNECTOR
MAINS
L
R
6 ΩMIN. /SPEAKER
SPEAKERS
L
R
SYSTEM
CONNECTOR
MAINS
TO SUBWOOFER
AUX IN
AUDIO
LINE OUT
AV MONITOR OUT
(
DVD ONLY
)
S VIDEO
VIDEO
COMPONENT
Y
P
R
PB
PCM/DTS
q DIGITAL
OPTICAL
DIGITAL IN
VIDEO OUT
(DVD ONLY)
AM
ANT
GND
TUNER
HDMI
FM
ANT
75Ω UNBAL
L
R
L
R
SYSTEM
CONNECTOR
SYSTEM
CONNECTOR
NX-SW1000