manual

TROUBLESHOOTING
60 En
Tuner (FM)
The picture is not displayed on the TV
screen.
The TV cables may be connected
improperly.
Make sure all cables are connected
properly.
17
If the COMPONENT VIDEO
OUTPUT and HDMI connections are
used simultaneously, the
COMPONENT VIDEO OUTPUT
jacks may output progressive video
signal regardless of the Component Out
setting.
Disconnect the HDMI component, or
connect a TV that supports progressive
video to the COMPONENT VIDEO
OUTPUT jacks.
18
The picture is not displayed on the TV
screen correctly.
The Video Output settings may be
incorrect.
Check the Video Output settings and
correct as necessary.
38
The Component Out setting is set to
Progressive, but the TV connected to
the COMPONENT VIDEO OUTPUT
may not support progressive scanning.
Change the Component Out setting to
Interlace.
38
The TV connected to the HDMI
OUTPUT terminal may not support the
selected resolution.
Change the HDMI Resolution setting
to a resolution supported by the HDMI
TV.
38
The message “HDMI ERROR” is
displayed or the picture is not
displayed on the HDMI TV screen.
The wrong HDMI resolution may be
selected or an HDMI error may have
occurred.
Check the HDMI Resolution setting
and correct as necessary.
38
Reset the HDMI settings. 57
Problem Cause Remedy
See
page
FM stereo reception is noisy. The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away, or
if the antenna quality is poor.
Check the antenna connections. 18
Try using a high-quality directional FM
antenna.
--
Use the manual tuning method. 46
There is distortion, and clear reception
cannot be obtained, even with a good
FM antenna.
There is multi-path interference. Adjust the antenna position to
eliminate multi-path interference.
--
The desired station cannot be tuned
into with the automatic tuning method.
The signal is too weak. Use a high-quality directional FM
antenna.
--
Use the manual tuning method. 46
Problem Cause Remedy
See
page