Manual

• Placing the center speaker

Place the speaker on TV whose top is flat or on the floor

under the TV or inside the TV rack so that it is stabilized.

When placing the speaker on top of the TV, to prevent the

speaker from falling down, put 1he provided fasteners at

four points on the bottom of the speaker and the top of the

TV.

• Mounting the front and rear

speakers

When mounting the front and rear speakers on a wall, use

the holes on the speakers' back panels.

U Put the provided pads at the four corners on

the rear of the front and rear speakers to

prevent the front and rear speakers from

moving by vibrations,

Peel off the

Fasten screws into a firm wall or wall

support as shown below.

• Do not place the speaker on top of the TV whose area is

smaller than the bottom area of the speaker. If placed, the

speaker may drop out causing an injury m you.

• Do not place the speaker on top of the TV with an inclination.

• Do not touch the adhesive surface after peeling off the seal as

this will weaken its adhesive strength.

• Thoroughly wipe clean the surface where the fastener is m be

applied. Note that adhesive strength is weakened if the surface

is dirty, oily or wet and that this may cause the center speaker

m drop.

• Placing the front and rear

speakers

When placing the front and rear speakers on a flat

surface, attach the included non-skid pads to the cornens

on the bottom of the speakers as shown below. This

prevents the speakers from sliding around.

• /

_ Non-skid pads

Diam. 3.5 to 4 mm

6 mill

Tapping screw

(Available at the

hardware s_ore)