Manual

.fIJAWl_l_#[lli_l
If you want to increase the power output to the speakers,
or want to use another amplifier, connect an external
amplifier to the 6CH PREOUT jacks as follows.
• When you have connected this unit lo an external amplifier,
select PRE in "9 SP/PRE OUT" on the SET MENU. (See page
6.3.)
O FRONT jacks
Front channel line output jacks.
REAR jacks
Rear channel line output jacks.
CENTER jack
Center channel line ouiput jack.
0 SUBWOOFER jack
Low bass signals disiributed from the front, cenier and/or
rear channels are direcied to this jack if they are assigned
to this jack. (The cut-off frequency of this jack is 90 Hz.)
The LFE (low-frequency effect) signals generated when
Dolby Digital or DTS is decoded are also direcled if they
m'e assigned to this jack.
Plug in this unit to the wall outlet.
• Memory back-up
The memory back=up circuit prevents the stored data from
being lost when the power cord is disconnected from the
AC outlet, or the power supply is temporarily cut due to
power failure. However, if the unit is turned off for more
than one week, the stored setting will be cleared. If so, set
the setting again.
Volume level
Input source
Speaker output level (center, rear L/R and subwoofer)
Sleep timer
Parameter
Delay time
Set menu
Disc direct
Preset station
When all connections m'e complete, turn on the power of
this unit.
STANDBY/ON
• The adjusiments made in the fk)llowing settings have an effect
on the signals output f]'om the 6CH PREOUT jacks.
-- BASS BOOST settings
-- Speaker settings
-- DSP programs
0
POWER (,3/I)
U Press STANDBY/ON (POWER (u/i) on the
remote control) to turn on the power of this
unit,
[] Turn on the video monitor connected to this
unit,
• When you use only some of the included 6 speakers or when
using commercially available speakers, adjust speaker mode
settings soon after turning the power on. See "1 SPEAKER
SET (speaker mode settings)" on page 60 f\)r details.
19