Manual

Checkyourpackagetomakesureitcontainsthefollowingitems.
DVR-S100
Remote control
G_C;_G_O
_J
Batteries (x2) AM loop antenna
(AA, R06, UM-3)
Indoor FM antenna
(U.S.A., Canada and (Europe, U.K. and
General models) Australia models)
NX-SW100 (NX-S100S x4, NX-S100C, SW-S100)
Fasteners (4 sets) Pads Non-skid pads
for the center (2 sets: 16 pieces) (2 sets: 16 pieces)
speaker
Speaker cables
(for the rear speakers: 15m (x2),
for the front/center speaker:
5m (x3))
System connector
cable (5m x 1)
M
:0
O
r-
{3
M
Z
Insert the batteries in the correct direction by aligning the
+ and - marks on the batteries with the polm'ity markings
(+ and -) inside the battery compm'tment.
t
\
[] Press the _ part and slide off the battery
compartment cover.
P_I Insert the two batteries (AA, R06, UM-3 type)
with + and - oriented properly.
I_] Slide the cover back on so that it snaps into
place.
• Notes on batteries
• Change all of the batteries if you notice a decrease in
the operating range of the remote control.
• Do no1 use old batteries togelher with new ones.
• Do no1 use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries ]nay have
the same shape and color.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material or
letting it come inlo contact with clothing, etc. Clean the
battery compartment thoroughly before installing new
batteries.
Preserving the manufacturer code
Replace batteries early before they become unusable.
The manufacturer code set by the user will be
preserved for about two minutes when batteries run
out or when they are removed. Note that the
manufacturer code setting may be lost if more than
two minules elapses. Also, if you press any button on
the remote control accidentally while replacing
batteries, the manufacturer code will be lost.
I
3