Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
- CONTENTS
- Preparation
- Basic Operations
- Viewing a DVD
- Useful Features
- Selecting the Audio Language
- Selecting the Subtitle Language
- Moving Forward and Backward
- Adjusting the Audio Volume
- Pausing Playback
- Switching the Viewing Angle
- Restarting Playback from the Stop Position (Memory Resume)
- Enhancing the Sound Presence
- Turning off the Sound
- Controlling the DVDs Your Children Can View
- Enhancing Video Quality
- Answers to Common Problems
- Sound Presence
- Advanced Features
- Selecting the Media Device
- Playing Video and Music Discs
- Listening to the Radio
- Using Other Equipment
- Creating the Best Listening Space
- More Information about DSP (Surround) Effects
- Selecting DSP Program Effects
- Using Matrix 6.1
- Using All Speakers for CD or Video playback
- Using Front Speakers Only for DSP Program (Virtual Cinema DSP)
- Using a DSP Program with Headphones (SILENT CINEMA)
- Using a DSP Program with Low Volume (Night Listening)
- Changing the Delay Time of a DSP Program
- Reproducing the Original Dolby and DTS Sound
- Reproducing Stereo Sound
- Selecting DSP Program Effects
- Types of Input Signals
- Additional Features
- Operating Other Equipment with the CinemaStation Remote Control
- Using the SET MENU
- Using the On Screen Menu
- Appendix
![](/manual/yamaha/dvx-s120/1-owner-s-manual-english/images/img-57.png)
53
Creating the Best Listening Space
Creating the Best Listening Space
Placing the Speakers (NX-P120)
Make sure the top of the television is level. If the top of the
television is not level, place the Center Speaker inside the
TV rack or directly on the floor. In any case, make sure it is
placed on a level surface.
When placing on top of the television, use the supplied
fastener (two pieces) as shown in the picture on the left,
between the bottom of the Center Speaker and top of the
television to fasten.
• Do not place on a television with top narrower than the bottom of the
speaker. You may get injured if the speaker falls over.
• Do not place if the top of the television is slanting. You may get
injured if the speaker falls over.
• After peeling off the fastener seal, do not touch the bonding surface. If
you do, the bonding surface weakens, which later may cause the
speaker to fall over.
• Before attaching the fastener to the television, wipe the TV top clean.
If the surface is dirty or wet tape will lose bonding strength, which
later may cause the speaker to fall over.
Placing the Center Speaker
Placing the Subwoofer
Place the Subwoofer on a level hard floor.
When placing, use non-skid pads on the bottom of the
Subwoofer in the four corners as shown in the picture. This
will prevent the Subwoofer from sliding when it vibrates.
Also, increasing stability prevents degradation of sound.
To get the most out of the sound field effects you need to place the speakers
in the best positions. To guard against poor acoustics like sound blur make
sure the speakers are stable. Also read page 7, Preparing the Speakers.
Note
Fastener
Peel off
the seal
English
012DVX-S120-en 03.8.5, 1:47 PM53