Manual

Connecting to a TV with an S video cable
Please follow the steps below before turning on the power.
1. If your TV has an S video input jack, connect the unit as shown in the
figure. (The MONITOR OUT VIDEO jack connection is not necessary.)
You can enjoy clearer picture playback.
2. Set the VIDEO OUT SELECT switch to S VIDEO.
DVR-S60
TV
S Video cable (not supplied)
Connecting to a TV with a component video cable
Please follow the steps below before turning on the power.
1. If your TV has component video input jacks, connect the unit as shown
in the figure. (The MONITOR OUT S VIDEO/VIDEO jack connection
is not necessary.) You can enjoy high quality picture playback.
2. Set the VIDEO OUT SELECT switch to COMPONENT.
DVR-S60
COMPONENT VIDEO INPL_ TV
Component video cable (not supplied)
VCR connections
With this connection, it is possible to watch and listen to videocassettes or
other video equipment.
Connect the 1st VCR as shown in figure (1)-(4).
If using the 2nd VCR or other video equipment, connect it as shown in
figure (5)-(6).
_) Video pin cable
DVR-S60
Video pin cable
VCR (1 st) VCR (2nd)
Audio pin
cab e
Note:
The picture from the VCR may be distorted in some cases.
If you use the VCR, you must connect the video pin cable between the MONITOR OUT VIDEO jack of the unit and the video input jack of the TV. There
are no VCR video signals from the MONITOR OUT S VIDEO and COMPONENT VIDEO OUT jacks of the unit.
Be su re to check and/or change the settings of the V IDEO OUT SELECT and V ID EO OUT SCAN SELECT switches before playing a DVD. If the setting
of either or both switches is changed during ptay, picture may be disturbed or disappear from the monitor. In such a case, turn this unit off and then
on again.
E-10