Manual

If you have followed the instructions and are having difficulty in operating the unit, locate the SYMPTOM in the left column below. Check the corresponding
POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem.
SYMPTOM
No picture.
POSSIBLE CAUSE
An improper source is selected.
No disc is loaded or an unplayable disc is loaded.
No sound.
The playback picture is poor.
"O" appears on the TV screen. The selected function does not operate on the
current disc.
The DVD pJayer does not start play. No disc is loaded.
An unplayable disc is loaded.
The TV is not set to receive signal from the unit.
An improper source is selected,
Vo;ume control is set to minimum.
An unplayable disc is loaded.
The disc is _oaded with the label side down.
The disc is dirty.
"PARENTAL" is set.
The operation or disptay is not normal, The memory must be reset,
The remote control does not work
properly.
The batteries in the remote control are weak, or
installed incorrectly.
The remote control is not aimed at the remote
control sensor.
CORRECTIVE ACTION
Select the correct source.
Load a disc or load a p_ayab_e disc. (Check the disc
_ogo, type, coIour system and regional code.)
Select the correct input function on the TV.
Select the correct source.
Turn up the volume.
Load a playable disc. (Check the disc logo, type,
colour system and regional code.)
The feature or action cannot be completed at this time
because:
The feature is not available at the moment.
The DVD software restricts it.
The DVD software does not support the feature
(e.g., angles).
Load a disc.
Load a playable disc. (Check the disc logo, type,
colour system and regional code.)
Load the disc on the disc tray correctly.
Clean the disc or replace it.
Cancel the parental _ock function or change the
rating level. Reset it after play,
1. Disconnect the power cable of the unit.
2. While pressing both BASS and MUSIC buttons
at the same time, connect the power cable,
3. Resume operation,
Check the battery polarity (+ or -).
Replace the batteries.
Aim the remote control at the remote control sensor.
E-25