Manual

1 To assure the finest performance, please read this manual
carefully. Keep it in a safe place for future reference.
2 Install this sound system in a well ventilated, cool, dry, clean place
with at least 10 cm on the top, 10 cm on the left and right, and tO
cm at the back of DVR-S6O, and 20 cm on the top, 10 cm on the
left and right, and 10 cm at the back of SW-S6O -- away from
direct sunlight, heat sources, vibration, dust, moisture, and/or cold.
3 Locate this unit away from other electrical appliances, motors, or
transformers to avoid humming sounds. To prevent fire or electrical
shock, do not place this unit where it may get exposed to dripping
or splashing, and never put any objects filled with liquids, such as
vases, on the top of the unit.
4 Do net expose this unit to sudden temperature changes from cold
to hot, and do not locate this unit in a environment with high
humidity (i.e. a room with a humidifier) to prevent condensation
inside this unit, which may cause an electrical shock, fire, damage
to this unit, and/or personal injury.
5 Avoid installing this unit in a place where foreign objects and liquid
might fall. It might cause a fire, damage to this unit and/or personal
injury. Do not place the following objects on this unit:
- Other components, as they may cause damage and/or
discoloration on the surface of this unit.
- Burning objects (i.e. candles), as they may cause fire, damage to
this unit, and/or personal injury.
- Containers with liquid in them, as they may cause electrical
shock to the user and/or damage to this unit.
6 Do net cover this unit with a newspaper, tablecloth, curtain, etc. in
order not to obstruct heat radiation. If the temperature inside this
unit rises, it may cause fire, damage to this unit, and/or personal
injury.
7 Do not plug in this unit to a wall outlet until all connections are
complete.
8 Do not operate this unit upside-down. It may overheat, possibly
causing damage.
9 Do net use force on switches, knobs and/or cords.
10 When disconnecting the power cord from the wall outlet, grasp the
plug; do not pull the cord.
11 Do not clean this unit with chemical solvents; this might damage
the finish. Use a clean, dry cloth.
12 Only voltage specified on this unit must be used. Using this unit
with a higher voltage than specified is dangerous and may cause
fire, damage to this unit, and/or personal injury. YAMAHA will not be
held responsible for any damage resulting from use of this unit with
a voltage other than specified.
13 To prevent damage by lightning, disconnect the power cord from
the wall outlet during an electrical storm.
14 Take care of this unit so that no foreign objects and/or liquid drops
inside this unit.
15 Do net attempt to modify or fix this unit. Contact qualified YAMAHA
service personnel when any service is needed. The cabinet should
never be opened for any reasons.
16 When not planning to use this unit for long periods of time (Le.
vacation), disconnect the AC power plug from the wall outlet.
17 Be sure to read the "TROUBLESHOOTING" section on common
operating errors before concluding that this unit is faulty.
18 Before moving this unit, press STANDBY/ON to set this unit in the
standby mode, and disconnect the AC power plug from the wall
outlet.
19 VOLTAGE SELECTOR (General model only)
The VOLTAGE SELECTOR on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the AC main
supply.
Voltages are 110-120V/220-240V V AC, 50 Hz.
This unit is not disconnected from the AC power source as long as it
is connected to the wall outlet, even if this unit itself is turned off.
This state is called the standby mode. In this state, this unit is
designed to consume a very small quantity of power.
IMPORTANT
Please record the serial number of this unit in the space below.
MODEL:
Serial No.:
The serial number is located on the bottom of the unit.
Retain this Owner's Manual in a safe place for future reference.
FOR CANADIAN CUSTOMERS
To prevent electric shock, match wide blade of plug to wide slot and
fully insert.
This Class B digital apparatus complies with Canadian ICES-003.
• For U.K. customers
If the socket outlets in the home are not suitable for the plug supplied
with this appliance, it should be cut off and an appropriate 3 pin plug
fitted. For details, refer to the instructions described below.
• The plug severed from the mains lead must be destroyed, as a plug
with bared flexible cord is hazardous if engaged in a live socket
outlet.
• Special Instructions for U.K. Model
IMPORTANT
THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE
WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK. The wire
which is coloured BROWN must be connected to the terminal which
is marked with the letter L or coloured RED.
Making sure that neither core is connected to the earth terminal of
the three pin plug.
DANGER
Visible laser radiation when open. Avoid direct exposure to beam.
When this unit is plugged to the wall outlet, do net place your eyes
close to the opening of the disc tray and other openings to took into
inside.
The laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
The is located the bottom of the unit.
name plate on
E-1