User Manual

ManualsBrandsYamaha ManualsAcoustic SystemsActive speaker systems

Panel Operations

q UNIT ID, LABEL

Shows the UNIT ID and label assigned so that DZR-D or DXS-XLF-D series devices on

the Dante network can be recognized. When the DANTE MODE (page 23) is set to

Quick Config, this will show as “QC,” and the name of the selected TF series output

channel. Go to the DANTE SETUP screen to configure and display Dante settings.

w Input Meter

Shows analog input signal levels. On Dante models this will appear as ANA.

Clipped input signals will light up at the top when clipping occurs.

e Input Meter (DNT)

Shows digital input signal (Dante) levels. Clipped input signals will light up at the top

when clipping occurs.

r MASTER Level

Sets and displays output levels. (Unit: dB)

t SP Output Meter

Shows output levels. Sigma () clipping at the top will light up when clipping occurs

within a channel.

y Protection (THERMAL, MUTED)

Appears when safeguard functions have been activated. “THERMAL” is shown when a

high temperature is detected in the amplifier, and output levels are reduced. If operat-

ing conditions further deteriorate, this will change to “MUTED,” and the output signal

will be muted.

u PRESET

Shows the preset number and title of the set preset. This enables you to save, load and

change audio settings. (E symbol) will appear when parameters have been

changed.

i HPF

Sets and displays the high-pass filter frequency.

LPF

Sets and displays the low-pass filter frequency and the POLARITY. An indication Ø will

appear when POLARITY is set to INVERTED.

o D-CONTOUR

Sets and display the D-CONTOUR mode.

D-XSUB

Sets and displays the D-XSUB mode.

!0 EQ

Shows whether the equalizer (6 Band EQ) is on or off. You can configure EQ settings

while checking the frequency response characteristics.

!1 DELAY

Sets and displays the delay.

!2 CARDIOID

Sets and displays the cardioid mode.

!3 ROUTER

Configures the routing of the audio signal.

!4 UTILITY

Sets and displays the device operating settings.

• PANEL SETUP: Sets the brightness and contrast of the display, and automatic turn

off settings for the display and indicators.

• PANEL LOCK: Configures panel lock settings, and saves and loads PIN codes.

• DEVICE BACKUP: Saves and loads settings data.

• DANTE SETUP : Sets and displays Dante-related settings.

• NETWORK : Sets and displays network-related settings.

• DEVICE INFORMATION: Shows device status, and device-specific information.

• INITIALIZE: Resets to the default settings.

• LOG: Shows recorded logs and saves logs to a USB flash drive.

• UPDATE FIRMWARE: Updates the firmware for the device, and the Dante module.

Dante model

Full range

Subwoofer

Full range

Subwoofer

Dante model