User Manual

Screen Functions
19
e OUTPUT
Sets the output level. Output levels can be set in 0.5 dB increments.
• ANA. OUT1 LVL: Sets analog output level A1 (page 7 o, channel 1 output level).
• ANA. OUT2 LVL: Sets analog output level A2 (page 7 o, channel 2 output level).
• DNT. OUT1 LVL: Sets Dante output level D1.
• DNT. OUT2 LVL: Sets Dante output level D2.
The UTILITY screen is used to configure device settings, and save and load settings data
to and from a USB flash drive.
 PANEL SETUP
Sets the rear panel display method.
q BRIGHTNESS
Sets the brightness of the back light of the display.
This setting can be set in 10 steps from 1 to 10.
 DZR-D series
Dante model
 DXS-XLF-D series
 DZR series
Standard model
 DXS-XLF series
UTILITY Screen
Dante model Standard model
Screen after scrolling
downwards
Screen after scrolling
downwards
w
q
e