Owner`s manual
Operation
28
NOTE:
●
It is not necessary to use the choke when
starting a warm engine.
●
If the choke knob is left in the “”
(start) position while the engine is running,
the engine will run poorly or stall.
5. Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
6. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
NOTE:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 30.
●
If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount and try again. Also if the en-
gine is warm and fails to start, open the
throttle a small amount and try to start the
engine again. If the engine still fails to
start, see page 57.
EMU27643
Electric start / remote control models
1. Place the remote control lever in neutral.
NOTE:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
WARNING
EWM00121
●
Attach the engine shut-off cord to a se-
cure place on your clothing, or your
arm or leg while operating.
●
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
●
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
ZMU02955
ZMU03008