Owner`s manual

Operation
30
6. Turn the main switch to “” (start),
and hold it for a maximum of 5 seconds.
7. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “” (on).
CAUTION:
ECM00191
●
Never turn the main switch to “”
(start) while the engine is running.
● Do not keep the starter motor turning
for more than 5 seconds. If the starter
motor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to “” (on), wait
10 seconds, then crank the engine
again.
EMU27670
Warming up engine
EMU27681
Choke start models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life. Gradually re-
turn the choke knob to its home position
as the engine warms up.
2. Check for a steady flow of water from the
cooling water pilot hole.
CAUTION:
ECM00511
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out
of the hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU34530
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
CAUTION:
ECM01610
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
STARTOFF
ON
ZMU02316
ZMU02968