User Manual

20
EAD10 Owner’s Manual
Setting Up
Setup Guide
2.
We recommend positioning the Main Unit so
that it is inside the outer edge of the cymbal
when viewed from above to avoid hitting the
Main Unit.
Use a drum key (sold separately) on the Main Unit angle
adjustment.
 Connecting the Cables
Connect the straight plug to the Main Unit, and the L-shaped
plug to the Sensor Unit.
Included Connector Cables
[A] jack on the rear panel of the Main Unit
[A] jack on the Sensor Unit
[B] jack on the Main Unit
[B] jack on the Sensor Unit
CAUTION
Do not connect or disconnect cables while the power is
ON.
About the Module Holder
The module holder has three sets of holes. Use the center set of holes to mount in a standard position. Use the
rear set of holes if you want the unit positioned forward, and use the front set of holes to position the unit to the
rear.
Main Unit
Front panel side
Rear panel side
Module holder
Main Unit
Angle adjustment key bolt
Module holder
Rear position
Standard position
Forward position
NOTE
The module holder is 22.2 mm (7/8") diameter.
Cymbal
Snare drum
(EAD10)
Main Unit
Sensor Unit