Operation Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
8-18
2
3
4
5
6
7
8
9
“HEAT” flashes in the display dur-
ing charging
This is not a malfunction.
The charging process is in the standby
mode because the battery temperature
is higher than 50 C. Allow the battery
to cool down.
When the battery temperature falls to
the specified temperature, “HEAT”
goes off and charging starts automati-
cally. (See page 6-1 for more informa-
tion about “Battery charging place”.)
“COOL” flashes in the display dur-
ing charging
This is not a malfunction.
The charging process is in the standby
mode because the battery temperature
is lower than –5 C.
If this occurs, start recharging in a
warm place.
When the battery temperature reaches
the specified temperature, “COOL”
goes off and charging starts automati-
cally. (See page 6-1 for more informa-
tion about “Battery charging place”.)
When the key is turned to “ON”, the
beeper sounds and the following
occurs
 The warning light flashes
 The warning mark “ ” comes on
 The battery level indicator seg-
ments move from side to side
 “PUSH” indicator and “OLD” indi-
cator alternately appear
1. Warning light
2. Battery condition indicator “CHG”
3. Warning mark “ ”
1. Temperature indicator “HEAT”
32
1
1
1. Temperature indicator “COOL”
1
1CB-9-EA.book 18 ページ ２０１２年４月１１日 水曜日 午前９時３４分