Owner`s manual

INSTRUMENT AND CONTROL FUNCTIONS
4-10
2
3
4
5
6
7
8
9
7. Push button 2 “SET”. The security
number flashes for a few seconds,
and then the vehicle enters the
riding mode.
TIP
 Be sure to record the security
number and keep it in a safe place.
 Pushing button 3 “SELECT”
switches the display between “OK”
and “NG”.
 To change the registered security
number, switch the display to “NG”
by pushing button 3 “SELECT”,
and then push button 2 “SET”. Re-
peat the procedure from step 5.
Locking and unlocking the security
lock
Locking the security lock
Push button 2 “SET” for a few seconds.
When the security lock is locked, the
security lock indicator “ LOCK” is dis-
played.
TIP
Do not lock the security lock when hav-
ing a Yamaha dealer perform service or
repairs on the vehicle.
Unlocking the security lock
Change to the standby mode by push-
ing one of the buttons, then enter the
security number. (See “Preparations
for starting off” on page 7-1.)
1. Security lock indicator “ LOCK”
1
1CB-9-E0.book 10 ページ ２０１０年１０月１５日 金曜日 午前１０時１９分