Owner`s manual

Table Of Contents

– 33 –

5. Wash the foam element in solvent and dry it.

Never use solvent while smoking or in the vicinity

of an open flame.

6. Oil the foam element and squeeze out excess oil.

The foam element should be wet but not dripping.

WARNING

Recommended oil:

Foam-air-filter oil or SAE #20 motor oil

Do not wring out the foam element. This could

cause it to tear.

7. Pull the foam element over the air filter element

frame.

8. Install the air filter element into the air filter case.

TIP

Be sure the air filter element sealing surface matches

the air filter case so there is no air leak.

The engine should never run without the air filter

element; excessive piston and cylinder wear may

result.

NOTICE

710-062

4. Remove the foam element from the air filter ele-

ment frame.

5 Foam element

6 Air filter element frame

710-061a

7CH-9-15-b 11.12.6 10:43 AM Page 33