User Manual

83 ELA-1 Reference Manual
9
Mixer
1 Press the [1] (Type) button to call up the window for selecting a Master EQ type.
2 Use the Cursor buttons to select the desired Master EQ type.
• Flat: Flat EQ settings. The gain of each frequency is set to 0dB.
• Powerful: Powerful EQ settings in which all frequency sounds are emphasized. This can be used to
boost the music for parties, etc.
• Mellow: Soft and mellow EQ settings in which high-frequency bands are reduced slightly.
• Bright: EQ setting for boosting the level of the high frequencies, making the sound brighter.
• With Subwoofer: Custom EQ settings in which low-frequency bands are reduced. This is an optimum
setting for using this instrument along with a subwoofer.
• User 1–30: Your own custom EQ settings saved in step 5.
3 Move the cursor to the desired position by using the Cursor buttons, and then use the
Data dial or the [u]/[d] buttons to adjust the “Gain” level of each band as well as the
“Q” (bandwidth) and the “Frequency” (center frequency).
Adjusting the value while holding down one of the [3]/[4] (Total Gain Adjust) buttons can boost or cut all
five bands at the same time.
The higher the value of Q, the narrower the bandwidth. The available Frequency range is different for each
band.
4 Press the [8] button to call up the “User Master EQ” window for the Save operation.
5 Use the Cursor buttons to select the destination for saving the settings as a User
Master EQ type.
If necessary, change the Master EQ name. Press the [3] (Rename) button to call up the Character Entry
window, enter the name, and then press the [ENTER] button. The Master EQ setting saved here can be
selected as described in steps 1–2.
1 3 4
[1]