User Manual

ELA-1 Reference Manual 92
10
Connections
By using a USB wireless LAN adaptor (UD-WL01; sold separately and may not be available in some areas),
you can connect this instrument with a smart device such as a smartphone or tablet via a wireless network.
For general operating instructions, refer to the “Smart Device Connection Manual” on the website. This
section covers only operations that are specific to this instrument.
Before starting operations, make sure that the USB wireless LAN adaptor is connected to the [USB TO
DEVICE] terminal and call up the setup display via [MENU]
→ Cursor buttons [][][E][F] Wireless
LAN, [ENTER].
NOTE If the USB wireless LAN adaptor is not recognized by the instrument, “Wireless LAN ” is not shown. When “Wireless LAN ” is not shown even though a
USB wireless LAN adaptor has been connected, turn the instrument off then on again.
When the connection is done successfully, “Connected” is shown at the top of the display, and one of the
icons shown below appears indicating the signal strength.
Infrastructure Mode
Making Wireless LAN Settings
[1]/[2] WPS Connects this instrument to the network via WPS. Press one of these buttons fol-
lowed by the [7] (Yes) button, and then press the WPS button on your access point
within two minutes.
[3] Mode Switches to the Access Point Mode.
[4] Detail For setting the detailed parameters. After making these settings, press one of the
[7]/[8] (Save) buttons to actually save them.
• IP Address: Sets the IP address and other related parameters.
• Others: Sets the Host name, Time Zone and Daylight Saving Time. When the
instrument is connected to the network with the Infrastructure Mode, the cur-
rent time is shown on the Main display.
[5]/[6] Initialize Initializes the connection setup to the default factory status.
Weak Strong