User Manual

Selecting Voices with the Voice Buttons
ELC-02/ELCU-M02 Owner’s Manual
26
There are two ways to set the Voice volume: using the
VOLUME buttons on the panel and using the volume
slider in the display. The VOLUME buttons let you make
coarse adjustments to the volume while the slider gives
you fine control.
Using the VOLUME buttons on the panel
(coarse)
Press one of the VOLUME buttons of the desired Voice
section on the panel to set the level for each Voice.
The buttons have five volume settings, from a minimum
of 0, or no sound, to a maximum of full volume.
Using VOLUME slider in the display (fine)
Pressing the same Voice button on the panel again (or
pressing the Voice name of the selected Voice in the
display) calls up the Voice Condition display.
To set the volume, touch the VOLUME slider in the
display or use the Data Control dial. The control range is
from 0 (no sound) to 24 (full volume).
NOTE
Depending on the volume value (set by the slider), two adjacent
VOLUME lamps may be lit at the same time, indicating an
intermediate position.
Changing the Voice volume
VOLUME slider
24
23
1
0
12
24
18
12
6
0
Calling up the Voice Menu display
and Voice Condition display
alternatively
Pressing a Voice button once calls up the Voice Menu
display for the selected button. Pressing it a second
time calls up the Voice Condition display. Successive
presses alternate between the two displays.
When the Voice Condition display is shown, pressing
the [VOICE MENU] button on the display also calls
up the Voice Menu.
From the Voice Condition display, you can control
Voice-related parameters such as Pan, Effect, Volume,
and so on. For more information on the Voice
Condition display, see page 41.
NOTICE
Turning the Electone off erases all panel settings you
have made.
If you wish to keep the panel settings you have made,
save them to a USB flash drive before turning the
Electone off (page 116).
Voice Menu display
Voice Condition display