User Manual
Table Of Contents
- Supported Models
- Supported iOS Devices and iOS
- Yamaha Applications for Piano & Keyboard Instruments
- Contents
- NOTICE
- Information
- Determining the Connection Type
- Connecting the Electone to an Access Point Using a USB Wireless LAN Adaptor (Connection A)
- Connecting Directly Using a USB Wireless LAN Adaptor (Connection B)
- Troubleshooting Problems with Wireless LAN Connections
- Connecting to an iPhone/iPad Using a Cable (Connection C, D, E, F, G, H)
- Glossary of Terms
- About Using BSD-Licensed Software
iPhone/iPad Connection Manual
8
Connecting the Electone to an Access Point Using a USB Wireless
LAN Adaptor (Connection A)
Wireless connection of the Electone to an iPhone/iPad, via an access point
using a USB wireless LAN adaptor
1
Turn off the power to the Electone.
Quit any open application software on your iPhone/iPad.
2 Connect the USB wireless LAN adaptor to the [USB TO DEVICE] terminal of the Electone.
3 Turn on the power to the Electone.
4 If your Electone has a wireless LAN mode setting, set it to Infrastructure mode.
For instructions on setting your instrument’s wireless LAN mode, refer to the Owner’s Manual or the New
Functions PDF of your Electone.
5 Connect the Electone to the network.
There are three methods of connection:
• Automatic setup by WPS (page 9)
• Displaying the networks in the wireless LAN and connecting to the network (page 10)
• Manual setup (page 11)
Select the appropriate setup method from the above depending on your network environment.
Required devices
• USB wireless LAN adaptor *
*For details about wireless LAN adaptor, contact your nearest Yamaha representative or the distributor listed at the end (or beginning) of
your Owner’s Manual. Or you can access the following website and contact Yamaha support at your location.
http://www.yamaha.com/contact/
• Access point with router (This is unnecessary if your modem has router capability.)
iPad
USB TO DEVICE
iPhone
Access point
Wireless
LAN
Wireless
LAN
USB wireless
LAN adaptor