ELECTRIC GUITAR エレクトリックギター OWNER’S MANUAL オーナーズマニュアル SGV SERIES SGV シリーズ
CARE AND MAINTENANCE Congratulations on your purchase of the YAMAHA electric guitar. With reasonable care, your YAMAHA electric guitar will age gracefully and provide many years of superlative musical service. 2 * When connecting or disconnecting cables, turn off the amplifier and other equipment or reduce the volume. * After playing, wipe the entire guitar down, including strings, with a good polishing cloth.
SGV800 Nomenclature 3-P P.U. Selector SW. Front P.U. Rear P.U. Front P.U. Front P.U. + Rear P.U. Rear P.U. Front P.U. Volume Rear P.U.
SGV700/SGV300 Nomenclature 3-P P.U. Selector SW. Pickup A Pickup A+(B+C)* Pickup (B+C)* Pickup A * The balance of pickup (B+C) depends upon the position of the Pickup Fader Control. Pickup B Master Volume Pickup C Master Tone Pickup Fader Control: Adjusts the output balance of pickups B and C. Turn to the right (clockwise) to increase the balance of the output from pickup B. Turn to the left (counter-clockwise) to increase the balance of the output from pickup C.
Truss Rod Adjustment Procedure Make sure guitar is tuned to pitch before making adjustments to the truss rod. The curvature of the neck should be slightly concave. The practice of sighting down the neck to see whether there is a bow or bend is unreliable, and even experienced bass technicians can be misted by optical illusions. A better method to check for proper curvature is as follows: Step 1: Tune strings to proper pitch, and depress the strings by placing a capo directly behind the first fret.
Adjusting String Height (Action) String height is indicated by the space between the strings and frets. Changing this setting will change the manner in which the guitar plays. If the string height is too high, it will be difficult to play, and if the string height is too low, it will cause fret buzz. 1. Loosen the strings. 2. Use the supplied box wrench to remove the anti slip nut on the 1st string and 6th string ends of the bridge. 3.
Bridge Saddle of SGV 300/800 Electric Guitars The bridge saddles may lift off of the bridge plate from intonation adjustments or vibration while transporting. To adjust the saddles, loosen the strings and press the hexagonal nut down towards the bridge plate to set bridge saddles in their original position.
Setting the Intonation Adjust the intonation by comparing the note fingered at the 12th fret with the harmonic tone at the 12th fret. Tune so that both pitches are the same. It is recommended that you use good quality strobe tuning scope for this function. * Please use the supplied Allen wrench to adjust the octave adjustment screw. • If the pitch of the note played on the 12th fret is sharp compared to the harmonic tone → Turn the octave adjustment screw to the right (clockwise).
Angle Adjustment for the Tremolo Unit Adjust the spring screw, located on the back side of the guitar body, so that the tail piece section of the tremolo unit is parallel to the body. If the string gauge or the position of the spring hook is changed, adjustment of the tremolo unit's angle (adjustment of the amount of floating) will be necessary. Tail section Adjust the height uniformly 1. Remove the four (4) cover fixing screws located on the back side of the guitar body and remove the cover. 2.
Adjust the Arm Tension Use the tension adjustment screw, located on the side of the tail piece, to adjust the tension that holds the tremolo arm in place. Insert the supplied Allen wrench into the tension adjustment screw on the side of the tail piece, and adjust the tension that holds the arm in place. • To make the arm tighter. → Turn the Allen wrench to the right (clockwise). • To make the arm looser → Turn the Allen wrench to the left (counter-clockwise).
SERVICE If your guitar should need any parts or service, or if you need any information, including the address of your nearest YAMAHA dealer, contact: YAMAHA CORPORATION OF AMERICA Guitar Service Department 6600 Orangethorpe Avenue Buena Park, Calif. 90620 Calif. U.S.A. TEL: 714 522 9433 YAMAHA EUROPA G.M.B.H. 2084 Rellingen, b. Hamburg Siemensstr. 22/34 Germany TEL: 04101 30 30 YAMAHA-KEMBLE MUSIC (U.K.) LTD.
QC55690 R1 0004 Printed in Taiwan